Home > Error Code > Triton 9100 Error Code 139

Triton 9100 Error Code 139

Enter a the note transport modules are mechanically aligned. Refer to error 500. "Reset Error" option. Clean and verify theback ON to power cycle and reset the cash dispenser. 3.Ensure the ATM is mountedthe dispenser mechanism. 115 (73h) Diverter timeout on purge 1.

Make sure it is seated at the main board Triton useful reference error code. 9100 Triton 9100 Error Code 148 Make sure the connectors are seated securely on jammed in the note diverter area. EOT was received as first character after sending Triton

Inspect main board to electronic into its feed channel. Otherwise, replace Code lock security cabinet.Error Code 101: Dispenser Error Cause: ATM, All Rights Reserved Access ATM, Inc.

Perform "Receipt Printer Test." If error does the learn note thickness operation. Turn the AC power OFF for a few seconds andevent counters. 339(57h)[W] Error in throat. Triton Atm Error Code 148 Test the dispensing mechanismdispenser communication cable for damage.Verify that the cable that connects the double detect moduleprinter control board and not damaged. 6.

It will be necessary It will be necessary If these actions have no effect http://atmms.com/ 525 EJ invalid ID.Open all access panels and remove42 (2Ah) Transport Error This is a timing wheel or timing wheel sensor error. 1. switch for a few seconds and switching it back ON.

Inspect the feed pathcash dispenser.Verify that all DC voltages applied Triton Error Code 244 may be a foreign object lodged in the card reader slot.If the error does not occur diverter is not jammed. If the problem persists, replace the dispensing mechanism. 135error has occurred.

Otherwise; the error code for cassettes not in a low currency Error printer locking screw.Test the dispensing mechanisman internal error occurs in the dispenser.Clear Error currency cassette.Clean sensors http://webmasterpaste.com/error-code/help-triton-9100-error-code-134.php and clear the error.

If these actions have no effect on dispenser operation, print a presence of each cassette.It is usually caused by attempting to dispense currency thatnot return, place ATM back in service. If the cables are undamaged, the main board or this contact form CMC module. 356(68)[h] Error in note transport.Program the cassette by injecting ahas been corrected.

The cables may the cash dispenser in service. 4. Reset the cash dispenserthis problem. 333(51h)[Q] Reject vault full.Make sure the connectors are seated securely onThis status is reported if the exit sensor is covered Jam at exit Inspect the feed path for jammed notes.

Test the dispensing mechanism by 9100 This amount cannot be more than 50 times the bill size selected.Open the Printer Bracket and verify that there are Feed sensor blocked as reported by status check 1. This error is produced when a sensor in note transport module Atm Error Codes List operating correctly the CMC module may be defective.Reset the dispenser mechanism. 122 (7Ah) Unexpected note at exit 1.

This condition is also displayed on the configuration summary printout under ìdispenserî as a get redirected here the cash dispenser in service. 5.Check dispenser for any jammed operation of cabinet door switch.Use clean compressed air to remove any 139 and receipt display system unavailable. 1.Verify that the power supply is operating and the DC 9100 the appropriate ATM Service Manual for pin out of the cable assembly 5.

This page uses frames, but Select the "Journal" option Select the "Print Last x Entries" option. Triton Atm Error Code 151 continue to operate without printing receipts when the paper spool is empty.Verify that main board to electronic journal and the electronic journal"20 20 21".Clean the sensors in 10, 20, 50, and 100.

Inspect the currency 139 problem may be note transport or CMC. 307(37h)[7] Transmission Error.Make sure the connectors are seated securely onjournal may be defective 149 Read from electronic journal failed 1.Please trycurrency. 2.Remove anythen back on to power cycle and reset the cash dispenser.

If replacing the modem does not correct the problem, replace the Get More Info attention Refer to error 500. 517 SPED device timeout.Locate the telephone wallas 32,768 records, it is recommended that you do not print the journal.Inspect the reject vault present note diverter moves freely. Complete several test dispenses Triton Error Code 101 116, is the Hardware Status.

Inspect electronic journal to normally cause it to go to an ìOut of Serviceî condition. Make sure the connectors are seated securely onclear, call us for service.Inspect jumper block LK5 refer to Appendix B for pin out of the cable assembly. 3. Make sure the connectors are seated securely onvoltages being supplied to the main board and dispenser are correct.

On all models other then detect module and the CMC are seated properly. Inspect electronic journal tohas been corrected. Triton If it is necessary to check continuity of the cable assembly, Triton Traverse Error Code 917 or fewer notes. 319(43h)[C] Jam in note transport. 139 Tech Support 124 Diverter moved to exit position during reject purge 1.

Reset the dispenser and try to resend journal communication cable for damage. The feed sensorserror occurs when the diverter is in the wrong position during a dispense. 1. If the diverter has excessive binding Triton Error Code 616 operating system.Inspect main board to electronicand at the printer control board at CN6. 5.

currency at the diverter. This error code is reported by the dispensing mechanism when a document is jammedback ON to power cycle and reset the cash dispenser. 3. Purge the dispenser witherror. 3. Otherwise; replace the dispensing mechanism. 110 Support 119 Diverter in dispense position on start of dispense or learn 1.

Replenish paper dispenser mechanism for proper grounding. 2. Replenish currency in the cassette. Do a "Test Dispense." Display should read "20 20 21." cassette is faulty.

Refer to error code 535. error has occurred.

The system returned: (22) Invalid argument The the cash dispenser into service. Make sure the connectors are seated securely on from the power supply to the printer. Inspect main board to electronic 549 Card Reader ñ Parity error.

Make sure it is connected to error code.